News Update

CB MODIPALM - SAND CYCLONE

SAND CYCLONE

Sand Cyclone serves to take the fine sand still in the sludge before it is processed in the sludge separator, so that the equipment in the sludge separator can be free from premature wear. Separation is performed on a centrifuge principle in which heavy density types are thrown to the outside and flowed to the bottom (ceramic cone). While parts of lighter weight will be thrown to the center and fed to a cyclone sand outlet.

Sand Cyclone Operational Procedure

1.The process of taking sand on a cyclone sand will work well if; Ceramic Coned in good condition (no wear and tear). The pressure difference between Inflow and Outflow is at least 2 bar.

2.Disposal of sand in the container tank should always be considered.

3. Check and notice Ceramic Cone or Stainless Steel Cone in good condition, no wear and leak.

4. Pump sludge from sludge tank to cyclone sand.

5. The difference in pressure between the inflow and outflow should ideally be at least 2 bars.

6. Notice the work of electrical automatic equipment (open and close valve setting) at the time of sand disposal at the container tank, sand discharge time and water entry time.

Specification

Sand Cyclone consists of cyclone, ceramic cone, actuator, desanding pump, pressure gauge and timer control. Pressure gauge mounted on inlet and outlet sandcyclone. The timer control setting functions to adjust the opening and closing of the sand drain valve in the cyclone sand. The timer control setting the closing position for 5 minutes opens for 15 seconds. "

 

Sand Cyclone serves to take the fine sand still in the sludge before it is processed in the sludge separator, so that the equipment in the sludge separator can be free from premature wear. Separation is performed on a centrifuge principle in which heavy density types are thrown to the outside and flowed to the bottom (ceramic cone). While parts of lighter weight will be thrown to the center and fed to a cyclone sand outlet.

Sand Cyclone Operational Procedure

1.The process of taking sand on a cyclone sand will work well if; Ceramic Coned in good condition (no wear and tear). The pressure difference between Inflow and Outflow is at least 2 bar.

2.Disposal of sand in the container tank should always be considered.

3. Check and notice Ceramic Cone or Stainless Steel Cone in good condition, no wear and leak.

4. Pump sludge from sludge tank to cyclone sand.

5. The difference in pressure between the inflow and outflow should ideally be at least 2 bars.

6. Notice the work of electrical automatic equipment (open and close valve setting) at the time of sand disposal at the container tank, sand discharge time and water entry time.

Specification

Sand Cyclone consists of cyclone, ceramic cone, actuator, desanding pump, pressure gauge and timer control. Pressure gauge mounted on inlet and outlet sandcyclone. The timer control setting functions to adjust the opening and closing of the sand drain valve in the cyclone sand. The timer control setting the closing position for 5 minutes opens for 15 seconds. "

HEAD OFFICE

PT. KHARISMAPRATAMA ABADISEJATINDO
Address : Jln. Kompleks Bumi Sunggal Blok C/E no 7, Medan – North Sumatera, Indonesia
Telephone : +62 61 8469822 - 8469806 - 8472878 Fax : +62 61 8469790
Email : sales.medan@kharisma-sawit.com; sparepart.medan@kharisma-sawit.com

JAKARTA REPRESENTATIVE

Telephone : +62-21-6332821/ 08561937055 / 0821108677322
Fax : +62-21-6345859
Email : sales.jakarta@kharisma-sawit.com
sparepart.jakarta@kharisma-sawit.com

For Information of Our product & Newsletter, please fill in below information